Marrada Angle

Share:
by zephram
Cloned from Marrada by zephram.

Download disabled

The designer of this FontStruction has chosen not to make it available for download from this website by choosing an “All Rights Reserved" license.

Please respect their decision and desist from requesting license changes in the comments.

If you would like to use the FontStruction for a specific project, you may be able to contact the designer directly about obtaining a license.

A variant of Marrada with more angles.

Usually with designs I try to make every part look like it "belongs" with the others as opposed to trying to make each part look its best. With Marrada, I struck a balance between the two. Q1@*&{} are probably the best examples of this sort of balance...

Info: Created on 21st January 2019 . Last edited on 26th January 2019.
License Creative Commons
Categories:
Sets:
Tags:
Fave Tags:
  • -

15 Comments

Very Neville Brody with that Q. I like it.

Comment by djnippa 21st January 2019

Thanks!

Comment by zephram 22nd January 2019

The En-dash could be a bit longer... Other than tkat, Nice one!

Comment by anonymous-1520403 22nd January 2019

I like this one better

Comment by JingYo 22nd January 2019

Cheers, @Se7enty-Se7en. I've made the Em Dash a brick wider in both versions of this. That makes it twice as wide as most letters... seems about right to me now.

Comment by zephram 23rd January 2019
Congratulations! FontStruct Staff have deemed your FontStruction worthy of special mention. “Marrada Angle” is now a Top Pick.
Comment by Rob Meek (meek) 25th January 2019

Thank you so much!

Comment by zephram 25th January 2019

For some curve, in your S, R and others.

Comment by FTrex 25th January 2019

10/10 Nice

Comment by FTrex 25th January 2019

@FTrex: Thanks! I tried just that while building this. There was always a slight protrusion on either side where you see the red arrows. Even at a smaller size where the points weren't visible, one could still tell something was amiss because those areas would always render with some extra antialiasing around them. So, it looked neater and better served the design to let the angles be sharply juxtaposed with the curves.

Comment by zephram 25th January 2019

I really like this. :)

Comment by TCWhite 28th January 2019

P.S.: I would make the ogoneks a bit longer. They generally are at the descender line, i.e., at the same level as p, q, y. . . . 

Comment by TCWhite 28th January 2019

Thanks for the kind words and suggestions, @TCWhite! By the way, I sent you a private message some time back...

Comment by zephram 30th January 2019

Yeah, I read it, and agree with you. The thorns, or any other letter, should conform to the design of the font.

Comment by TCWhite 30th January 2019

Very nice font! I like the copyright and registered symbols a lot and it lights me up when I see this set. Good job!

The 'Q' has a unique design.

Comment by Spaceman032 27th March 2019

Also of Interest

More from the Gallery

Novus Graecorumby zephram
Pixel Flamesby zephram
Bulwarxby zephram
Lasagna Cowboyby zephram
db Sodaby beate
lupoby four
fs lostby ETHproductions
Hi-NRGby V. Sarela (Yautja)

From the Blog

News

New Bricks: Square Connectors

News

The Video Game Font Preservation Society

News

FontStruct goes open source!

News

New Bricks: Half Arcs